Joined: Sat Oct 21st, 2017
Interests: Life, Experiences, and adventures.
Reputation Points: 1886
|Not a permanent Solution BUTTTTTTT, when I picked up a transfer case one time. The previous owner had an issue with his shift motor too. His temp solution was taking a 12 point socket, you'll have to figure out what will fit & with tighter tolerances to keep from just stripping anything, and tap it on with a mallet.. your choice of a 3/8" or 1/2" size is relative to use. I have a full 10mm-36mm sockets on my end I could check with them for fitment too. But you should be able to manually change 2WD/High/Low easily with removal of the motor and a ratchet/socket
"Be never first, never last and never noticed." - Unknown
"The slave is held most securely when he is held by the chains of his own will and of his own fears, and when he is locked down by his own slavish desires for a comfortable life." - Michael Bunker
"Mundus vult decipi, ergo decipiatur. Mundus vult decipi, ergo decipiatur" - ~ attributed to Petronius (Gaius Petronius Arbiter (ca. 27–66 AD))
Roman courtier during the reign of Nero.
"Those who expect to reap the blessings of freedom, must, like men, undergo the fatigue of supporting it." - Thomas Paine
~ Undrstm8ed Truckumentry Write Up Pg.
~ Undrstm8ed Trailermentry Write Up Pg.