1
View single post by chris
 Posted: Sun Dec 29th, 2024 03:35 pm
PM Quote Reply Full Topic
chris
Wrench spinner


Joined: Thu Oct 5th, 2017
Location: Leigh On Sea
Posts: 723
Status: 
Offline
Reputation: 
Reputation Points: $user_rep
Member's Gallery
 If it is near the bottom hose then it will be measuring the temp of the cooled water leaving the rad - that is why they put it up top, usually just under the thermostat to measure the temp of water leaving the block.

There is normally a bypass to allow the water to circulate the block when the thermostat is closed - the gauge sensor needs to be in that circuit!



____________________
MG power