| PM | Quote | Reply | Full Topic |
Old Bastard !
Joined: Fri Dec 22nd, 2017
Location: California USA
Posts: 2108
Status:
Offline
Reputation: 
Reputation Points: $user_rep
Your opinion please, would you use a solid axle D44 or add to the D35 in an '03 Ranger ?
I am partial to a solid axle except for the extra height tha tis needed to install it, I don't like the 6 or 7" type lifts.
Reason for asking... I have access to a stretched Early Bronco Frame (111.7" WB), yes a lot of work but swapping the Ranger Body to that frame isn't out of the question.
I have a local shop that will make mounts and swap the body and wire a three wire engine harness to run off exiting wiring for just over 3K$. Seems reasonable with the amount of work that would be needed.
Last edited on Wed Feb 12th, 2020 09:47 pm by Scrambler82
____________________
Ltr,
2003 EDGE, Std Cab, Steppie, E4 Red, 5sp, 4x
5" SuperLift, 33" x 12.50 x 15"
Hurst Shifter
Mod'd Backrack to fit Steppie
Front and Rear Bumpers by Custom 4x4 Fabrication, OK; now Mike's Welding and Fabrication.
Working on more Mods, just need more time, longer days would work !