New Audio On The Way !
Joined: Fri Dec 22nd, 2017
Name: Grev B
Occupation: Quality Assurance Engineer
Interests: Rangers, Photography, Metal Bending
Reputation Points: 2698
Maybe on the Steppie you could section the rear fenders
Is that yours?
No, mine is RED, there are pictures around.
Here it is: https://ford-rangers.com/forum45/875.html
Scrambler82, you can take one of the Edge flares, put short, sharpened (bench grinder) roofing nails into the mounting holes where the little christmas tree fasteners go, secure with a very small amount of hot-glue. Then use the Edge flare with nails to transfer holes to paper to make your hole template. While the template is still pierced by the nails, trim the paper template to fit along the top outside edge of the flare as accurately as possible. Remove the nails and lay the Edge flare on to the bedside, and mark (pencil, marker, etc) around the outside of the flare while pushing firmly upward on it, into the wheel well. Then lay the new template on the bedside to mark your hole locations, while lining up with the outer/top marks you made earlier. Your hole locations should end up very accurate this way.
Kinda hard to get the point across in words..
A good suggestion, I might try it when I get there, thanks.
I'm wondering if sectioning the rear Fenders is a good option ?
Last edited on Fri Oct 12th, 2018 12:01 am by Scrambler82
2003 EDGE, Std Cab, Steppie, E4 Red, 5sp, 4x
5" SuperLift, 33" x 12.50 x 15"
Mod'd Backrack to fit Steppie
Front and Rear Bumpers by Custom 4x4 Fabrication, OK; now Mike Welding and Fabrication.
Working on more Mods, just need more time, longer days would work !